Triniyt F90+ Remote ID
For the Remote Id for the Trinity F90 I need to know the Serial Number of you payload or get a photo of your PMB on the payload.
You need to access to your payload compartment to see if only the Remote ID kit is needed or if a ready bay compartment is needed instead, open up the payload compartment cover (exposing access to the PMB board) and look for the following connector (circled in red in the photo below) on the PMB board. If the connector (not the cable with black wires, but the actual connector) is present on the board, only the Remote ID kit is needed, but if the connector is missing from the board, a ready bay compartment is needed.
I can then quote this for you.
On the F90+ each payload requires a Remote ID module.
Related Articles
Remote ID for Drones
A list of currently Remote ID capable drones can be found here: https://uasdoc.faa.gov/listDocs Most drones made release after September 2022 have the Remote ID Capabilities built in. Most made before that do not have Remote ID natively and will ...Remote ID - Autel Robotics
To comply with FAA regulations, Remote ID capability will soon be released for all our major drone series. This feature will monitor the drone’s location and broadcast identification information while in flight. This will make it easier to fly our ...Part 107 FAA Resources
State and Local Regulation of Unmanned Aircraft Systems - The FAA has pre-emptive authority over airspace. States and local governments may not regulate in the fields of aviation safety or airspace efficiency but generally may regulate outside those ...Remote ID for Public Safety Guidance from the FAA 08-30-2023
Parrot Anafi GOV - Remote is Disconnected
It is not uncommon for the drone and remote to disconnect after a firmware update. The first step is to reboot both drone and controller. If it remains unbound, with both powered on please connect the remote's USB-C port to the drone's USB-C port (on ...