Tether Repair Kit

1. Cut off the broken adapter
   
2. Strip the cable back and strip the individual cables to fit on the new adapter
   
3. Slip clear tub over wire
4. Solder the wires to the corresponding spots below. #1 position is the white wire.  #2 position is the black wire
   
5. Bench test with ROV to ensure it functions
   
6. Align tube over wires
7. Fill with Marine Flexible epoxy and let cure  - https://amzn.to/3sbeSy4  This may take 2 sessions.
   
8. Water test drone.
   

The other issue could be a broken mini jack. This is the part we use to replace that end if continuity is not working.

https://amzn.to/3NV58nt

Minijack

• Related Articles

• QySea Questionaire

  If you can answer some questions about your QySea use that would be help for us. *Please click here to take QYSEA Questionnaire*

• QySea VR headset setup

• QySea Fifish V6 Motor Repair

  Cut off the wire to the motor ESC close to the old ESC Strip the cable back and strip the individual cables to fit into the new ESC.  Strip only 2-3 MM. Solder the wires to the corresponding spots below. Bench test motors. Fill with Marine Flexible ...

• QySea FiFish V6 HDMI Box Setup

• Programming the Payload Release System for Matrice 600 with the Channel Expansion kit

  Once the hardware is installed on the Matrice 600 and wired to a port you will need to program the Channel Expansion and Matrice 600 Pro. Follow the Instructions to install the Channel Expansion module on the remote controller.  This video will help ...