QySea Fifish V6 Motor Repair

1. Cut off the wire to the motor ESC close to the old ESC
   
2. Strip the cable back and strip the individual cables to fit into the new ESC.  Strip only 2-3 MM.
   
3. Solder the wires to the corresponding spots below.
   
4. Bench test motors.
5. Fill with Marine Flexible epoxy and let cure  - https://amzn.to/3sbeSy4  This may take 2 sessions.
   
6. Water test drone.

• Related Articles

• QySea Fifish V6 Series RC Calibration

  Watch this video to learn how to calibrate the standard remote controller for the QySea ROVs

• QySea FiFish V6 HDMI Box Setup

• QySea Questionaire

  If you can answer some questions about your QySea use that would be help for us. *Please click here to take QYSEA Questionnaire*

• QySea Fifish App - IOS - will not connect to drone

  If you turn on you drone the lights go solid on the remote, but you cannot connect to the ROV please check the following settings: To enable Local Network access for an app on your iPhone: Open Settings. Go to Privacy & Security → Local Network. Find ...

• QySea V6 Propeller Installation

  Here are 2 types of propellers for the V6 series propellers. Please follow these instructions for the proper location 2 Clockwise 4 Counterclockwise This applies to the V6, V6S, V-EVO, V-6 Expert, E-GO, and V6 Plus