How to change the E-GO propellers and thrusters in 5 easy steps

QySea E-Series Thruster Replacement (propeller replacement)

To replace the thruster on the E-GO series.  Use the following Steps.

1. Remove the Shroud screws

2. Remove the 4 Motor Connector Screws

3. Detach the motor power connector

4. Remove Motor Mount Screw

5. Remove and Replace Thruster with propeller

The propeller is not replaceable on the thruster alone.  You must replace the entire part.

After replacing the thrusters, resecure with the screws in reverse order.

    • Related Articles

    • QySea Fifish V6 Series RC Calibration

      Watch this video to learn how to calibrate the standard remote controller for the QySea ROVs

    • QySea V6 Propeller Installation

      Here are 2 types of propellers for the V6 series propellers. Please follow these instructions for the proper location 2 Clockwise 4 Counterclockwise This applies to the V6, V6S, V-EVO, V-6 Expert, E-GO, and V6 Plus

    • QySea Questionaire

      If you can answer some questions about your QySea use that would be help for us. *Please click here to take QYSEA Questionnaire*

    • QySea Warranty Information

      PART I – LIMITED WARRANTY These QYSEA After-Sales Policies (these “Policies”) only apply to QYSEA products you purchased from QYSEA authorized retailers or QYSEA directly for your own use and not for resale. These Policies are available in other ...

    • Tether Repair Kit

      Cut off the broken adapter Strip the cable back and strip the individual cables to fit on the new adapter Slip clear tube over wire Solder the wires to the corresponding spots below. #1 position is the white wire. #2 position is the black wire Bench ...