CDC Mavic 2 PRCS Elites

CDC Mavic 2 PRCS Elites

Power Requirements for Up to Three (3) Mavic 2 PRCS Elites


Each Mavic 2 PRCS Elite fully loaded with 4 batteries and a controller “at peak” uses about 5.5 amps from the 120VAC circuit.

This translates to an average of 660 Watts AC needed for 1, Mavic 2 PRCS Elite charger.

For 2, Mavic 2 PRCS Elite’s from the same source, you will need on average about 1300 Watts AC.

For 3, Mavic 2 PRCS Elite’s from the same source, you will need on average about 2000 Watts AC.

Inverters/generator power sources should be rated between 1.2X and 1.5X the wattage required by the load, i.e. Mavic 2 PRCS Elite charging systems. Note: all our charging systems are designed to be powered from a “modified sine wave” continuous power source – this can save you a lot of money over buying a “pure sine wave “power source.

  1. To power 1 Mavic 2 PRCS Elite we recommend a power source between 750 Watts and 1,000 Watts.
  2. To power 2 Mavic 2 PRCS Elite we recommend a power source between 1500 Watts and 1,750 Watts.
  3. To power 3 Mavic 2 PRCS Elite we recommend a power source between 2200 Watts and 2,500 Watts.

Be sure to use the proper wire size.


    • Related Articles

    • Do I need to register my DJI Mavic Mini Drone?

      The DJI Mavic Mini comes in at 249 grams as the weight.   (https://www.dji.com/mavic-mini/specs).  The Mavic Mini weighs only 249 grams According to the FAA if the drone is under 250 grams you do not need to register it for recreational use.  Keep in ...

    • What Camera does the Mavic 3 Enterpise Have?

      The Mavic 3 Enterprise series has 3 different camera types. Camera Types: Mavic 3 Enterprise - RGB Camera with mechanical shutter, primarily used for mapping 3d, reconstruction models, etc. Mavic 3 Thermal - A Thermal combo camera with a RGB camera ...

    • QySea Fifish HDMI Box Setup

      The HDMI box can be powered by the Remote Controller AC charger and the short cord included with the HDMI box or it can be powered by a phone charger that meets the 5V 3Amps requirements of the HDMI box.

    • Solar Inspection Resources

      The Mavic 3 Thermal, The EVO Max 4T, The Teledyne Flir Siras are all good candidates for thermal inspection drones. https://www.blueskiesdroneshop.com/collections/solar There are good resources for thermal mapping and inspection. ...

    • Laser Methane Sensor for Matrice 600

      Thank you for renting from Blue Skies Drone Rental! Please review this guide for getting your LMC up in the air quickly. 1.       We verify each unit is ready for flight before we ship out the units, but we want you to verify no damage has occurred ...